The OPC server is intended for communication with Honeywell DDC's using C-BUS driver
- Main Highlights
- Unique solution for Windows 2000/XP/Vista and Windows 7/8/10

- Possibility of communication across the Ethernet via C-Bus interface
(low-cost solution comparing BNA - Building Network Adapter)
- Possibility of parallel communication over multiple serial or network
interfaces
- Response time up to two seconds by change of state notification!
- Full-valuable solution including Time Programs and Parameters

- It is also available for Excel
EMC and IRC Multicontrollers
- Server Properties
- The OPC server performs value change notification and cycle reading
of defined points (User Address)

- Reading and Writing from DDC points of type: Digital Input, Digital Output, Analog Input, Analog Output,
Totalizer (Slow & Fast), Pulse, Multistate, Pseudo Digital (Virtual) and Pseudo Analog (Virtual)
- Support for following extended attributes: HighLimit1, HighLimit2, LowLimit1, LowLimit2,
AlarmDelay, SensorOffset, AccumulatedRuntime, ServiceInterval,
TimeSinceServiced,
SuppressAlarm, PointEnabled, RuntimeEnable, ActiveState, AlarmType and AlarmStatus
- Compatible with controllers of Excel 5000 family (XL50,
XL80, XL100, XL500, XL600
and XL800)
- It is possible to connect the OPC server to C-BUS in conjunction with
Excel Building Supervisor (XBS),
Excel Building Supervisor-Integrated (XBS-i), SymmetrE and Enterprise Buildings Integrator (EBI)
- The OPC server is available in versions for 255, 1.000, 2.000, 5.000,
10.000 and 20.000 points
- The OPC server attempts to renew lost connections
- Network data transfer support (via DCOM)
- The OPC client's configuration is performed using names of points and
controllers
(supported by IOPCBrowseServerAddressSpace)
- Compatibility with the OPC Data Access 1, 2 and 3 specifications
- Compatibility with the OPC Alarms & Events specifications 1.10
(Excel’s alarms are reported by OPC Alarms & Events standard)
- Ability to synchronize date and time of Excel controllers
- Unlimited number of OPC client connections
- Built-in simulation mode for testing
- The OPC Server can run as a Service (only for Windows NT/2000/XP)
- ActiveX component for editing Time Programs
and Parameters
- HW and SW requirements


- IBM PC or compatible computer
- Pentium processor
- Minimum 64 MB RAM
- Minimum 5 MB of free disk space
- Windows NT 4.0 + SP6 or higher
or Windows 2000/XP/95/98/ME
- DCOM installed
- Free serial port or Ethernet card
- Intelligent External Converter (IEC)
[Download the Datasheet in PDF format
(90kB) ...]
[Download the User's Manual in PDF format
(145kB) ...]
Question & comments: info @ cbusopcserver.com
Last Updated: 06.02.2016